LiquidityScan

· ENTRY MODELS & TIMING · 11 MIN READ · UPDATED TODAY

How to Trade USD/JPY With ICT Concepts: Reading the Pair Whose Home Session Is Tokyo

How to Trade USD/JPY With ICT Concepts: Reading the Pair Whose Home Session Is Tokyo

USD/JPY is the one major whose home session is Tokyo, so the Asian range is real business rather than a quiet box. Here is how to read its bias, liquidity, sweep and entry with ICT concepts, and where that read breaks down.

The short answer

Trading USD/JPY with ICT concepts follows the same order as any other pair. Read the daily bias, mark where stops are resting, wait for price to sweep one of those levels and close back, confirm the turn on a lower timeframe, then enter on the retrace with the stop beyond the sweep. What changes is the clock. The yen's home market is Tokyo, so the Asian session, which on EUR/USD is mostly a quiet box to mark and wait on, is where USD/JPY does real business. Some days Tokyo builds the range that London later raids. Other days Tokyo makes the first leg of the move itself. Telling those two days apart is the part of the job that is specific to this pair.

What makes USD/JPY different from the other majors

Tokyo is the home session

Japanese banks, importers and exporters deal in yen during Tokyo hours, so USD/JPY receives genuine order flow while London and New York are closed. ICT (Michael J. Huddleston) frames the day around kill zones, fixed windows in which liquidity tends to be taken and moves tend to start. The Asia kill zone runs from 20:00 to midnight New York time, which is Tokyo's morning. On a European pair that window is something you mark and leave alone. On USD/JPY it can be the window that sets the day's high or low.

Japan does not change its clocks

ICT windows are quoted in New York time and move with US daylight saving. Japan has no daylight saving. The Tokyo open, 9:00 in Tokyo, therefore lands at 20:00 New York time during US summer time and at 19:00 during US winter time. If you draw the Asian range from a fixed New York hour, it includes the Tokyo open for part of the year and skips its first hour for the rest. Pick one definition and keep it. The guide to converting ICT session times between timezones covers the arithmetic.

The pip is the second decimal

A pip on USD/JPY is 0.01, not 0.0001 as on EUR/USD. A stop that sits 0.30 away in price is 30 pips. The pip's value is in yen, so it has to be converted into your account currency before you size the trade. The walkthrough on using a position size calculator for forex shows the conversion.

Rates and officials move it

USD/JPY is sensitive to the gap between US and Japanese interest rates. US data moves it in the New York morning, and Bank of Japan decisions arrive in Asian hours, when traders of other majors are used to quiet. Japanese officials have also stepped into the currency market in the past. A move of that kind ignores every level on the chart, which is why discipline around high-impact events matters more here than a cleaner entry model does.

The USD/JPY day in ICT terms

Window (New York time)What it means on USD/JPYWhat to mark or wait for
Asia kill zone, 20:00–00:00Tokyo's morning. Yen flow is active. Price either ranges or makes a directional leg.The session high and low, and whether the range is tight or already stretched.
London kill zone, 02:00–05:00European desks arrive and the Asian high or low is an obvious pool of stops.A sweep of one side of the Asian range and a close back inside it.
New York kill zone, 07:00–10:00US data and the dollar side of the pair take over.Continuation of the London move, or a sweep of the London high or low followed by a turn.

Traders do not all draw the Asian range over the same hours. The method matters less than using the same one every day, and the article on how to mark the ICT Asian range sets out the common versions.

Step by step: an ICT read of USD/JPY

1. Set the daily bias from a closed candle

Use the last closed daily candle. A close above the previous day's high gives an upward bias for the next day. A close below the previous day's low gives a downward one. A close inside the previous day's range gives no bias from this rule, and the honest response is to ask more of the setup or sit out. Most forex feeds roll the daily candle at the New York close, a few hours before Tokyo opens, so on USD/JPY the bias is fresh when the home session begins. If you would rather not check this by hand, see how a daily bias scanner reads every market before the session.

2. Mark the liquidity

Liquidity here means resting stop orders. Mark the previous day's high and low, the Asian range high and low once Tokyo has printed them, any equal highs or equal lows (two or more swing points at almost the same price), and the nearest round figure, since orders cluster at prices ending in .00. With an upward bias, the level you want to see raided is a low.

3. Wait for the sweep and the close

A liquidity sweep is a move through a marked level that fails to stay there. The wick goes through and the candle closes back on the original side. If a candle body closes beyond the level and the next candle holds there, you are looking at a breakout, not a sweep. Judge the close on the 15-minute or 1-hour chart, not on a tick. The comparison of a liquidity sweep and a breakout goes through the borderline cases.

4. Ask for a shift before you believe it

A sweep alone is a wick. The confirmation is a change on a lower timeframe, 15 or 5 minutes. Two versions are in common use. A CISD, change in state of delivery, is a candle closing back beyond the open of the run of candles that carried price into the sweep. A market structure shift (MSS) is a close through the last swing point that formed on the way in. Either one should arrive with displacement, meaning a fast move of large-bodied candles away from the level. The CISD entry model explains how to find the exact level.

5. Entry, stop and target

Displacement usually leaves a fair value gap (FVG), a three-candle gap where the wick of the first candle and the wick of the third do not overlap. It also leaves an order block, the last opposing candle before the displacement. The entry is a retrace into one of those zones. The stop goes beyond the sweep wick. The first target is the opposite side of the Asian range and the next is the previous day's high or low. A candle close beyond the sweep extreme invalidates the idea.

A worked example in words

The numbers below are illustrative, not a forecast. Yesterday's daily candle closed above the prior day's high, so the bias is up. Tokyo trades between 150.20 and 150.80 and goes quiet. Early in the London kill zone, price drops through 150.20 to 150.08, and the 15-minute candle closes back at 150.26. That is the sweep of the Asian low.

The run into that low began with a down candle that opened at 150.34. The next 15-minute candle is large, closes above 150.34 and leaves a gap between 150.30 and 150.38. That is a CISD with displacement and an FVG. Price drifts back into the gap. An entry there with a stop a few pips under 150.08 risks roughly 30 pips. The first target is the Asian high at 150.80, and the previous day's high sits above it.

The idea is dead if a 15-minute candle closes below 150.08. It is also weaker than it looks if Tokyo had already swept both sides of its own range before London arrived, because the stops this setup depends on were taken hours earlier.

When Tokyo trends instead of ranging

On some days Tokyo does not build a box. Price leaves the open with displacement and keeps going, and by midnight New York time the "Asian range" is a single directional leg. Fading the high or low of that leg in London is a different trade from fading the edge of a tight range. The extreme was made by real flow and may not be a pool of stops waiting to be raided.

On those days a more consistent ICT read is to treat Tokyo's move as the first leg. If it agrees with the daily bias, look for London to retrace into the FVG or order block that Tokyo left and continue. If it runs against the bias, wait for it to reach a higher-timeframe level before looking for a turn.

Where this read fails

  • The range is already stretched. A wide Asian range puts the stop far away and leaves little room to the opposite side. The model assumes London has work left to do.
  • No close back. A wick through the Asian low followed by a second close below it is a break. Buying it because "it swept" is the most common mistake on this pair.
  • No daily bias. After an inside day, both sides of the Asian range are equally plausible targets and the sweep tells you less.
  • Event risk in Asian hours. A Bank of Japan decision or an official comment on the yen can run through the range, the FVG and the stop in one candle.
  • It is the yen moving, not the pair. When yen is being bought or sold across the board, USD/JPY and the yen crosses move together, and a level on one chart means little. Checking a cross helps, as described in the guide to trading GBP/JPY with ICT concepts.

The model also says nothing about distance. A confirmed sweep tells you where a turn may have started, not how far it will travel.

How to follow USD/JPY on LiquidityScan

USD/JPY is one of the seven majors in LiquidityScan's Forex mode, which covers 72 instruments. The All Scanners page in Forex mode lists all 15 scanners with live counts, and each card shows how its pattern works. Pages inside the app need a free account.

  • Free plan. The eight classic scanners on 1H, 4H, 1D, 1W and 1M. Three of them map onto the steps above. Bias sets a bullish or bearish bias when the previous close breaks beyond the candle before it. CRT flags a sweep of a range high or low followed by a close back inside. CISD flags the change in state of delivery. The seven premium scanners show a live count on Free, not the setups.
  • Asia Range Sweep. This is one of the premium seven. It triggers on an Asian-range liquidity sweep plus a reversal, aligned to a daily bias. Starter opens all 15 scanners to browse, and alerts on the premium scanners belong to Base and above.
  • Timeframes. Most scanners work on 1H, 4H and 1D, plus 1W and in some cases 1M. Only Fair Value Gaps and CISD+ also have 5m and 15m, and those two intraday timeframes belong to the Base plan and above. It is not a scalping tool, so the 5-minute read in step 4 remains yours to do on your own chart.
  • Closed candles only. A USD/JPY sweep that is still a wick inside a forming candle is not reported until that candle closes.
  • Following the pair. Star USD/JPY on any scanner page and it joins your Watchlist, which collects its signals from every scanner. Price alerts with browser push are part of the Free plan, so the Asian high and low can each carry one.

LiquidityScan is software and education, not a signal service. A detection is context for your own decision, and the platform never tells you to buy or sell.

Frequently Asked Questions

What is the best time to trade USD/JPY with ICT concepts?

Three windows matter. The first is Tokyo's morning, the Asia kill zone from 20:00 to midnight New York time, where the range or the first leg forms. The second is the London kill zone from 02:00 to 05:00, where the Asian high or low is often raided. The third is the New York kill zone from 07:00 to 10:00 on US data days. The best one for you is the one you can watch consistently.

Does the Asian range work on USD/JPY the way it does on EUR/USD?

Only on some days. When Tokyo ranges, the sweep of the Asian high or low in London reads the same way as on EUR/USD. When Tokyo trends, the session high or low was made by real yen flow, and treating it as a box to fade is a misread.

Which timeframes should I use for USD/JPY?

A common split is the daily chart for bias, the 1-hour or 15-minute chart for marking the Asian range and judging the sweep's close, and the 15- or 5-minute chart for the CISD or structure shift and the entry zone.

How many pips should the stop be on USD/JPY?

There is no fixed number. The stop belongs beyond the sweep wick, and the distance from your entry to that point is the risk. On this pair a pip is 0.01. If the distance is too large for your account, the answer is a smaller position or no trade, not a tighter stop inside the structure.

Can I scan USD/JPY on LiquidityScan for free?

Yes. With a free account the eight classic scanners, including Bias, CRT and CISD, are readable on 1H, 4H, 1D, 1W and 1M in Forex mode. The seven premium scanners, Asia Range Sweep among them, show a live count on Free and open to browse from Starter.

What happens to ICT setups around Bank of Japan decisions?

They become unreliable. A decision or an official comment can move USD/JPY through the Asian range, the entry zone and the stop within one candle, and no sweep or gap accounts for that. Many traders simply mark the event time and stand aside around it.

Hayk Muradian

Hayk Muradian

Founder & Lead Analyst at LiquidityScan · 12+ years ICT/SMC trading · Institutional order flow specialist

Hayk Muradian is the founder of LiquidityScan, a professional trading intelligence platform built for ICT (Inner Circle Trader) and Smart Money Concepts (SMC) traders. With over a decade of hands-on experience reading institutional order flow across crypto, forex, and futures markets, Hayk specializes in identifying liquidity events, order blocks, and CISD setups on closed candles.

He built LiquidityScan after years of frustration with retail charting tools that ignored the mechanics institutions actually use. The platform now scans 400+ markets in real-time, surfacing the same patterns floor traders watch — without the noise.

Hayk writes about the methodology behind ICT and SMC, with a focus on practical, data-driven analysis rather than hype. He is a vocal critic of "smart money" content that misrepresents institutional intent and a strong advocate for methodology-respectful education.

View all 387 articles by Hayk Muradian →

Not trading advice. LiquidityScan publishes educational content for informational purposes only. Trading involves substantial risk of loss.